SpeakerTalk Forum Index SpeakerTalk
This forum has been set up to facilitate discussion of 1970s KEF speakers and drive units. The owner of the Forum has no connection with KEF Audio.
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

How do I connect the Kube 103.3 to my amp

 
Post new topic   Reply to topic    SpeakerTalk Forum Index -> KEF speakers
View previous topic :: View next topic  
Author Message
whapper_98
Introductory Contributor


Joined: 02 Jun 2006
Posts: 4

PostPosted: Tue Jun 20, 2006 9:25 am    Post subject: How do I connect the Kube 103.3 to my amp Reply with quote

Can someone let me know how to properly connect the kube to my amp? Someone suggested that I should connect my amp's tape loop output to the Kube's signal input and then connect the Kube's signal input to my amp's tape loop input. Is that right? I'll be grateful if someone lets me know or posts a link to the relevant Kef diagram
Many thanks
Back to top
View user's profile Send private message
speakerguru
VIP Contributor 750+


Joined: 18 Nov 2005
Posts: 954
Location: Green Hut, Tovil

PostPosted: Tue Jun 20, 2006 12:50 pm    Post subject: Reply with quote

I have a KUBE 100 Installation Manual which shows the two alternative connection schemes. I can email it to you if you get your address to me in the spam avoiding method of your choosing.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    SpeakerTalk Forum Index -> KEF speakers All times are GMT + 1 Hour
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group