SpeakerTalk Forum Index SpeakerTalk
This forum has been set up to facilitate discussion of 1970s KEF speakers and drive units. The owner of the Forum has no connection with KEF Audio.
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Naim+ kube 103.3

 
Post new topic   Reply to topic    SpeakerTalk Forum Index -> KEF speakers
View previous topic :: View next topic  
Author Message
erik_bjorge@hotmail.com
Introductory Contributor


Joined: 04 Aug 2016
Posts: 3

PostPosted: Fri Nov 11, 2016 12:08 am    Post subject: Naim+ kube 103.3 Reply with quote

Hi
I have a nice Naim cb nac 32.5(with ryanlab boards)/ avondale tpx1/ cb Naim 160 and Kef ref 103.3.....and bryston bda-2/bdp-1as source
How to connect - and what kind of cables do I need to connect the kube...?
Erik
Back to top
View user's profile Send private message Send e-mail
speakerguru
VIP Contributor 750+


Joined: 18 Nov 2005
Posts: 954
Location: Green Hut, Tovil

PostPosted: Fri Nov 11, 2016 10:17 am    Post subject: Reply with quote

Please read the sticky
http://www.hifiloudspeakers.info/speakertalk/viewtopic.php?t=1723
re signal levels.

I suggest you use 5 pin DIN to 4 phono leads whether you use the tape monitor or the pre to power option. In the latter case you will only use two of the 4 leads going from preamp to KUBE. You will need a further 5pin DIN to 2 phonos for the KUBE to power amp.
Back to top
View user's profile Send private message
erik_bjorge@hotmail.com
Introductory Contributor


Joined: 04 Aug 2016
Posts: 3

PostPosted: Fri Nov 11, 2016 11:38 am    Post subject: Reply with quote

speakerguru wrote:
Please read the sticky
http://www.hifiloudspeakers.info/speakertalk/viewtopic.php?t=1723
re signal levels.

I suggest you use 5 pin DIN to 4 phono leads whether you use the tape monitor or the pre to power option. In the latter case you will only use two of the 4 leads going from preamp to KUBE. You will need a further 5pin DIN to 2 phonos for the KUBE to power amp.


Hi
Thanks!
Erik
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    SpeakerTalk Forum Index -> KEF speakers All times are GMT + 1 Hour
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group